18HP Walk-Behind Chain Trencher Shipped To European Customer

Nov 16, 2026

Leave a message

18HP Walk-Behind Chain Trencher Shipped to European Customer

Company news · November 2026

In short: one 18HP diesel walk-behind chain trencher has been built, tested and shipped to a customer in UK. It is a trial unit - the customer will run it on cable work before deciding on further machines. The unit left the factory fitted with a 15 cm / 5.9 in chain and the standard electric-hydraulic boom lift.

18HP Walk-Behind Chain Trencher

The unit was crated with the chain and teeth coated, the boom blocked and a moisture barrier against container condensation.

What was shipped

The machine is the production version of the 18HP walk-behind chain trencher described on our product page: an air-cooled diesel engine, a chain-and-tooth digging assembly, two lugged drive wheels with a front caster wheel, and a control handle that rotates through a full 360°.

Unit specification as shipped
Model 18HP walk-behind chain trencher
Engine Air-cooled diesel, 18HP
Trench width 12–40 cm (4.7–15.7 in), set by chain width
Trench depth 10–100 cm (4–39 in), set by chain width
Chain fitted 15 cm (5.9 in)
Boom lift Electric-hydraulic, controlled from the handle
Handle 360° rotatable
Work efficiency 150–200 m/h (490–660 ft/h)
Quantity in this shipment 1 unit
Destination UK, EU

Checks before crating

Every unit goes through the same sequence before it is packed. For this shipment the sequence was:

Cold start and idle check, then a loaded run-in with the chain cutting soil.

Chain tension set, digging teeth checked and re-torqued.

Digging boom cycled through the full stroke to confirm the electric-hydraulic lift holds depth without creeping.

Hydraulic lines and fittings checked for seepage.

Fasteners checked throughout; paint touched up where the crate straps sit.

Chain and teeth coated with rust preventive.

Operator manual and spare parts list packed inside the crate.

Machine blocked inside a plywood case, strapped, with a moisture barrier against condensation in the container.

18HP Walk-Behind Chain Trencher

Chain tension and tooth torque are set before the machine is blocked into the crate.

Why a trial unit first

Contractors in landscaping and utility work often take a single machine before committing to a fleet, and it is easy to see why. A specification sheet cannot tell a buyer how the chain behaves in local soil, whether the trench holds depth over a long pull, or how the machine handles a run tight against a kerb or a boundary wall. One unit on one real site answers those questions in a week.

If the trial goes well, the same chain widths and the same boom can be ordered again without a redesign, which keeps the second order short.

Set up for European sites

Three details matter more in Europe than anywhere else, and all three are standard on this machine:

Metric trench sizes. Six chain widths - 12, 15, 20, 25, 30 and 40 cm - cover irrigation pipe, cable conduit, land drainage and root barriers without changing machines.

Work in confined space. The 360° handle lets the operator stand on the side with the best view of the chain and the marked line, so a run along a wall, a fence or a planted border needs no repositioning of the machine.

One operator. Drive, trench depth and the handle are all controlled from the operating position. No second person is needed on the boom.

The engine is air-cooled, so there is no radiator, coolant or water pump to fill or service on site.

Order the same configuration

Tell us the trench width, trench depth and total length in metres, plus the soil type on site. We will confirm the chain configuration, lead time and shipping terms.

For the technical specification, the chain-to-depth chart and the full FAQ, see the 18HP walk-behind chain trencher page.

Request price and lead time →

Send Inquiry
One-stop service
Warmly welcome your inquiries and visiting
contact us