Equipment Installation Steps:
- Install sensors and controllers: Install the required sensors and controllers for the laser grader on the grader. Attach the sensors to the upper part of the grader and mount the controller on the tractor.
- Connect equipment: Connect the sensor and controller to each other. Ensure the connections are correct before fixing them onto the grader.
- Install laser transmitter and sensing equipment: Position the laser transmitter and sensing equipment between the tractor and the grader.
- Adjust altimeter: Adjust the altimeter to meet the specific requirements of the work at hand.
Operation Steps:
- Pre-start inspection: Ensure that all equipment is functioning properly.
- Combine tractor and grader: Connect the tractor to the grader and set the tractor in motion as needed for the task.
- Adjust the height of the grader: The operator should adjust the height of the grader based on the laser sensor's readings, ensuring the ground's flatness matches the height displayed by the laser sensor.
- Set the slope: If necessary, use the controller to adjust the slope of the ground according to the required specifications.
- Shut down the equipment after work is completed: Turn off the switches on both the tractor and grader, move them to a safe location, and shut down the equipment.
